Instructions
All our laptop stickers and webcam covers are reusable. Find out how to apply, remove and reuse our MacBook decals and privacy stickers.
CamTag
Cover your camera with CamTag when you’re not using it, and peel it off for video calls. Follow the instructions below to apply, remove, and reuse it, or watch the 1‑minute instruction video to see how CamTag webcam covers work. Learn more about CamTag.
Apply CamTag
1. Clean
the camera on your device. Make sure the surface is free of dust and cleaning detergent residues.
2. Apply
a CamTag that is slightly bigger than your camera, peel it off the packaging, and place it over the camera.
3. Hold
the CamTag in place for a few seconds so that the adhesive-free film can do its magic.
Remove CamTag
1. Remove
CamTag carefully, using your fingernail or by sliding a sheet of paper between the CamTag and the surface.
2. Store
CamTag next to the camera (without covering any sensors) or in its packaging, so the adhesive side stays clean.
Reuse CamTag
1. Follow
the instructions above on how to apply CamTag. You can reuse CamTag multiple times.
TabTag
Use TabTag to give your MacBook a personal touch by covering the Apple logo, and swap designs whenever you like. Follow the instructions below to apply, remove, and reuse it. Learn more about TabTag.
Apply TabTag
1. Clean
the lid of your MacBook with a dry cloth and make sure there is no dust.
2. Lift
the tongue on the lower right of the TabTag decal and peel it off the packaging.
3. Align
the TabTag to cover the Apple logo on your MacBook.
4. Apply
the TabTag carefully and enjoy the view.
Remove TabTag
1. Lift
the tongue on the lower right of the TabTag decal and peel it off your MacBook.
2. Store
TabTag in its packaging to keep it clean.
Reuse TabTag
1. Follow
the instructions above on how to apply TabTag. You can reuse TabTag many times. If it gets dusty, rinse it with cold water and let it dry before reusing it.
